Local Reviews
for Pickerington, OH
Powered by Nearby NowGreat service, great follow-up!
Rachel - Pickerington, OH
We bought a new furnace and air conditioner. They did a good job installing and the follow-up inspection.
Furnance check up
Greene - Pickerington, OH
No issues with the Furnace check. Vibration and noise issue was taken care of.
great
Smith - Pickerington, OH
nice speedy service
Very professional and knowledgeable
Lewis - Pickerington, OH
James and Ben were very professional.
Great service.
J.C. Young - Pickerington, OH
Isaiah was informative, enthusiastic and got the job done!
Awesome Service
Walke - Pickerington, OH
Josh was on time, mindful of my home after the inspection he shared knowledgeable information that was helpful in my decision. He was professional and I look forward to my next service with an employee from Pickerington Heating and Cooling.
Adam S.
I installed a Carrier 80% 45,000 BTU Gas Furnace
Adam S.
I installed a Carrier 96% Two-Stage 80,000 BTU Gas Furnace and a Carrier up to 17 SEER 2 STAGE 3 Ton Air Conditioner
Haidar H.
High limit on the air handler is open, system is cooled down but high limit won’t close. Client wants the high limit replaced.
Haidar H.
High limit on the air handler is open, system is cooled down but high limit won’t close. Client wants the high limit replaced.
Haidar H.
High limit on the air handler is open, system is cooled down but high limit won’t close. Client wants the high limit replaced.
Isaiah C.
After running diagnostic tests, I determined the issue was either with the inducer motor or heat exchanger. Per customer's approval, I will come back to replace inducer motor since it is the cheaper fix and we will go from there.
Adam S.
I installed a Carrier 96% 60,000 BTU Gas Furnace and a Carrier 16 SEER 2.5 Ton Air Conditioner
Isaiah C.
I provided an estimate for a Carrier 96% 80,000 BTU Gas Furnace
Isaiah C.
We found the voltage drop on G terminal we replaced the existing Honeywell T6 pro thermostat. The thermostat is what energizes the blower when the system is calling for cooling or heat pump heat.
Isaiah C.
I completed a diagnostic on a Carrier heat pump with an electric air handler. Upon arrival heat pump was turned off and client was using auxiliary heat. I turned on the heat pump. Cycled and monitored the system. I inspected and tested the heat pump. Was unable to get heat pump to repeat noise reported by client. It is possible there is an intermittent issue. Possible that the blower motor is not receiving a signal to turn on. This either from the thermostat not sending voltage or the relays that control the blower motor failing. Client will monitor system and if it happens again then the relays can be replaced. Cycled and monitored the system. Operating normally at this time.
